Russound SIX-SOURCE CONTROLLER CAM6.6 Manuel d'utilisateur télécharger pdf (Page 40)

The RNET Link In and Link Out can be used to

connect two to six CAM6.6 or CAV6.6 con-

trollers. The connection is made using a CAT-5

patch cable from the Link Out of the master

CAM6.6 and into the Link In of the next con-

troller. Along with RNET data signals, the RNET

Link In and Link Out jack passes the six source

IR signals. These are only for source-specific IR

remote repeating, not codes initiated from the

controller’s internal IR library. The CAT-5 patch

cable should not exceed 18 inches in length to

avoid potential cross-talk between the source-

specific IR repeating signal lines.

The RNET Link In and Link Out is also used to

connect the CAM6.6 to other Russound prod-

ucts with RNET.

Note: If two or more CAM6.6 or CAV6.6 con-

trollers are connected using the RNET Link In

and Link Out ports, each controller must have a

unique Controller ID prior to being connected

through the RNET ports. The Controller ID

assignment must be performed during the

Controller Setup section of the Installation menu.

If using a CAM6.6T, be sure to set the Controller

ID under “Peripheral Setup” to “ALL CON-

TROLLERS” (page 50).

Note: It is not recommended to link together

two CAM6.6T controllers. If designing a CAM6.6

system with more then one tuner, use two

CAM6.6 controllers and a Russound ST2 Dual

Tuner (also ST2-XM, ST2-XM2, ST2S). See page

CAM6.6

CAV6.6 (Controller ID 2)

CAM6.6 (Controller ID 1)

CAT-5 Cable (MAX LENGTH 18 INCHES)

INSTALLER

MAKING CONNECTIONS

RNET Link In and Link Out

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 115 116

Pas de commentaire

Russound SIX-SOURCE CONTROLLER CAM6.6 Manuel d'utilisateur Page 40