Russound DPA-1.2 Manuel d'instructions télécharger pdf (Page 39)

The R-NET Link In and Link Out is used to con-

nect two or more CAV6.6 controllers. The con-

nection is made using a CAT-5 patch cable from

the Link Out of the master CAV6.6 and into the

Link In of the next CAV6.6. Along with R-NET

data signals, the R-NET Link In and Link Out jack

passes the six source IR signals. These are only

for source-specific IR remote repeating, not

codes initiated from the controller’s internal IR

library. The CAT-5 patch cable should not

exceed 18 inches in length to avoid potential

cross-talk between the source-specific IR repeat-

ing signal lines.

Note: If two or more CAV6.6 controllers will be

connected using the R-NET Link In and Link Out

ports, each controller must have a unique

Controller ID (see Controller Setup - Flow

Chart on page 65) prior to being connected

through the R-NET ports. The Controller ID

assignment must be performed during the

Controller Setup section of the Installation menu.

The R-NET Link In and Link Out is also used to

connect the CAV6.6 to other Russound products

with R-NET.

INSTALLER

MAKING CONNECTIONS

R-NET Link In and Link Out

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 91 92

Pas de commentaire

Russound DPA-1.2 Manuel d'instructions Page 39