Russound ACCLAIM 7 Manuel d'installation télécharger pdf (Page 8)

8 Russound Acclaim Thin Bezel Loudspeaker Installation Manual

INSTALLATION

Installation

1. Remove the grill from the speaker, if applicable.

2. Connect the speaker wire to the speaker terminals:

• Leave about 2' (60 cm) of wire extending through the ceiling cutout.

• Pull the conductors apart so the last two inches are separated and

remove ½ " (13 mm) of insulation from the end of each conductor.

• Twist the strands in each conductor into tight spirals.

• Attach the speaker wires to the red and black speaker terminals. Connect

the Positive (+) conductor to the Red terminal and the Negative (-)

conductor to the Black terminal. Make sure that no stray strands of wire

are touching the other conductor or terminal.

• Single point speakers have four terminals; Right(+), (-) and Left(+),

(-). Run an extra pair of conductors and observe proper polarity when

making connections.

Insertion of speaker wire on back of speaker ba e

3. Center the speaker in the cutout. Rotate the frame as needed before

tightening the screws. Tighten the screws equally until the clamps secure

the frame. Do not overtighten.

Speaker

As screws are tightened

clamp will rotate out and

snug against the drywall.

Cutout

Screw

Speaker Cable

Install Speaker

+



1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Russound ACCLAIM 7 Manuel d'installation Page 8