Russound Collage Manuel d'installation télécharger pdf (Page 15)

15Russound Collage System Installation Manual

WIRE AND CABLE FEED

Electrical wire pull

Do what is necessary to prepare the electrical wire feed from the light

switch or electrical outlet for installation. If using wire requiring more

bend radius, or if the keypad is to be installed closer to a light switch,

the back box and power pocket can be inverted as shown. The diagram

at right shows the upside down installation of the back box and power

pocket.

Note: Keep in mind the recommended keypad height is 59 inches (150

cm) for optimal screen viewing.

Speaker cable pull

The CAK1 supports two pair of 8-ohm speakers (up to a 4-ohm load).

These are typically installed in the same room as the keypad.

Speaker cable should be run to the back box location before the back

box is installed. Once the cable is fed through the back box, strip 3/16"

(4.7 mm) from the ends of the speaker cable (16 AWG) and insert into the

removable snap connector, keeping channel and polarity correct.

FM antenna wire (monopole)

The CAK1 includes a monopole antenna for the FM tuner. Before

installing the back box, extend the wire and place it so it runs down and

out the small side opening of the back box and hangs outside the box

inside the wall.

FM antenna wire (coaxial)

The CAK1 supports an optional external 75-ohm coaxial antenna (up

to RG6). Run the coaxial cable to the back box location. Thread the cable

through the top of the back box and pull through.

Optional inverted back box installation

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Russound Collage Manuel d'installation Page 15